Del City Interactive Catalog Page 336

336 battery cables & accessories Scan for pricing or go to www.delcity.net/ catalogpricing Battery to Battery Charger ProMariner's Digital Mobile Charge (Battery to Battery) is a breakthrough in battery to battery, on-the-water charging technology. Simply connect to the engine crank battery and your house electronic battery, allowing for up to 40 Amps per hour to be transferred to your house battery bank. It protects your engine battery while charging and conditioning your house battery bank, using its all-digital software controlled, multi-stage charging technology. The 4th Stage provides on-demand fast charge mode when needed. Meets a boat's demand for on-the-water power and charging for 12 or 24V DC systems, allowing for radar, lighting, live wells, and other DC systems to operate while managing and charging batteries when running your engine. Programmable Battery Type Selector allows selection of Flooded (lead-acid), AGM, and GEL batteries, and Hi-Vis LEDs indicate battery type, charge modes, temperature, and fault conditions. Ignition protection, over temperature protection, and over- voltage protection. Remote temperature probe included. Lead-free. part no. description 905505 digital mobile charge, battery to battery, 40 Amp, 12V to 24V part no. description 905513 digital mobile charge, alternator to battery, 130 Amp, 12V Alternator to Battery Charger ProMariner's Digital Mobile Charge (Alternator to Battery) on-the-water charging system provides a significant increase in charging capacity of up to 130 Amps. Simply connect your alternator to the Digital Mobile Charge (Alternator to Battery), then connect the Digital Mobile Charge (Alternator to Battery) to your engine crank battery and house electronic battery bank. It will provide up to 130 Amps per hour to your house battery bank while protecting your engine battery and charging/conditioning your house battery bank, using its all-digital software controlled, multi-stage charging technology. Meets a boat's demand for on-the- water power and charging for 12V DC systems, allowing for radar, lighting, live wells, and other DC systems to operate while managing and charging batteries when running your engine. Programmable Battery Type Selector allows selection of Flooded (lead-acid), AGM, and GEL batteries, and Hi-Vis LEDs indicate battery type, charge modes, temperature, and fault conditions. Ignition protection, over temperature protection, and over voltage protection. Remote temperature probe included. Lead free. RoHS NEW Battery Chargers These on-board, solid state, 3-stage battery chargers offer a single 10, 20 or 35 amp, 12V DC output to recharge your battery to its optimal level. The chargers are encapsulated in an epoxy potting compound that provides superior protection against water damage and are reverse polarity protected. Full recovery time is 6 to 8 hours based on an approximate time to restore a 100 amp hour deep cycle battery at 60% discharge. Input cable is 6' long with AC receptacle attached and voltage rating is 110 to 120 volts 60Hz AC with a maximum draw of 2 amps at 115V AC. Output cables are 4' long with 3/8" ring terminals attached and rating is 10 amps at 12V DC. Charger dimensions are 5.1" x 7.75" x 2.4" and approximate weight is 6 lbs. part no. description 991515 10 amp battery charger 991520 20 amp battery charger 991535 35 amp battery charger 991515 991535 Battery Isolators ProMariner Battery Isolators are solid-state devices that allow electrical current to flow in one direction only. They efficiently utilize the energy produced by the alternator/s and distribute the power evenly to each battery. The isolators allow the batteries to charge together but isolate each battery during operation. They allow one or two alternators to be connected to multiple battery banks without fear of fully charged batteries discharging into undercharged batteries. Please note that these products are meant to be used with negative ground alternator systems, and are not recommended for use with self-energizing style alternators. Rated for use with 6, 12, 24, 32, and 36V DC systems ranging from 10 amps to 130 amps output. part no. alternators batteries amps 901702 1 2 70 901703 1 3 70 902702 2 70 902703 2 3 70 911302 1 2 130 911303 1 3 130 921302 2 130 921303 2 3 130 902702 P i d t b i n s a NEW

Previous Page
Next Page